Adblueobd2 For Man Euro 6 Truck Scanner Adblue Emulator Euro6 For Trucks with NOX sensor With Adblue 8 IN 1/9 in 1, Adblueobd2 Emulator for MAN Euro6
EURO6 AdBlue Emulators Disable System: AdxBlue system (Fully)
AdxBlue NOX sensor, DPF system, DPF temperature sensors, DPF regeneration
After installing Euro6 Emulator, you can remove: DPF sensors - YES, NOx sensor - YES (only in DAF don't remove first NOx sensor !!!), Adblue temp. sensor (s) - YES, Adblue pump - YES, Adblue level sensor - YES, Adblue ECU - YES
Kindly note: It is possible to disable AdxBlue system by installing an AdxBlue emulator (programmable device) into the vehicle. You can switch it on/off anytime.
EURO6 AdBlue Emulators using guide:
Emulator Man Euro 6 does not need to be learned. You install emulator under the metal cover of AdBlue Pump on the right side behind the cab, and disconnect plug from AdBlue Pump and connect emulator.
Next, you need to remove the fuses:
F894(Multisensor In AdBlue tank)
F738 (+30 Signal of AdBlue pump)
F1084 (NOx sensor Upstream)
Fuse F737 is now fuse of emulator.
Fuse F1109 is the fuse of NOx sensor Downstream and A1191 mufler temperature sensor. This sensor needs to work correctly for DPF regeneration.
Finally you need to remove Power from NOx downstream sensor. There are two ways options, one is to cut pin 1 in NOx sensor plug, the other way (better) is to remove pin 10 in X3212 plug. This plug is visible on rear of engine on the right side. This is TE plug (16 pin) with yellow key.
Color: As Shown
Material: plastic
Package Contents:
1 x Emulator for MAN Euro 6
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.