This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
Shipped from abroad
Free return within 7 days for eligible items.Details
CharacterL
100%Seller Score
26 Followers
Shipping speed: Excellent
Quality Score: Excellent
100W TYPE-C decoy PD 2.0 3.0 TO 5V 12V 15V 20V DC trigger Adapter cable QC4 charge Charging notebook Module
Descrtion:
Features:A PD decoy 5V 9V 12V 15V 20V fully supported, hardware jumper solder joints set the voltage, there is no wrong touch or poor contact or cr resulting in voltage errors. Very low static power consumption 1.5mA DIY by yourself, built into various devices that require 5-20V, set the voltage, compatible with PD power supply, The maximum 20V5A100W support, the specific output power depends on how much the charger supports the corresponding gear. Volume: length 21mm width 11mm thickne 4.3mm Input protocol: PD2.0 or PD3.0 Trigger gear: 5V, 9V, 12V, 15V, 20V, see the figure below for the specific setting method Static power consumption: le than 1.5mA in all gears Output pads: 4 pitches of 2.54mm, square negative round positive Method of setting voltage: As shown in the figure, the red dot represents two pad haes connected by a drop of solder. The output is connected to 20V by default. It is recommended to actually check the output voltage before use. If you set 15V, connect the four jumper pads on the front with 20V, and then connect the 15V jumper pads on the back.
About shping
This product has no ratings yet.
Subscribe to our newsletter
and be the first one to know about our amazing deals!