127PCS Shrink Tube EU US Plug Heat Gun for Shrink 300W 220V Portable Hot Air Fan Heating Gun for Epoxy Resin Remove Bubbles ing

# s★ Main Product:Hot Air Gun★ Plug Type:EU Plug 220V /US Plug 120V★ Heat Gun Power:300W★ Achievable Temperature:200℃★ Rated Voltage:220V /120V★ Widely Application:Heat gun for ing, epoxy resin,DIY Craft Emboing, Shrink Wrapping PVC, Drying , Clay, Rubber Stamp, etc# About This ItemPortable Heat Gun for DIY Craft Emboing, Shrink Wrapping PVC, Drying , Clay, Rubber Stamp

√ 100% and High Quality ABS and PC plastic material, it equip with the stainle steel bracket to rotate 100 degre. It is Very compact and ble, practical

√ Keeping 5-6cm distance from work and about a 45 degree angle to heat until it is completed. It not only can add its hardne, but also its brightne

√ There are heat vents in left and right sides to decreased the internal temp and extend its lifetime

√ This excellent compact heat gun can be used for heating shrinkable film, emboed powder,rubber stamp, the best choice to rep toaster or oven and the polymer clay will become hard and bright after using the gun

√ The temprature can not be adjusted, but in theory, it can reach at about 200 degree within a few seconds absctly. But do not use it more than 10 minutes, just you can turn off then turn on again for working continuously

# How to Use the Heat Tool★ Plug in the heat tool. Hold the product as shown on the pict.(Do not touch the hot nozzle.)★ Keeping3-5cm distancefrom work and about a45-degree angleto heat until it is completed. (Do not blow the hot air gun directly at 90° to the object.)★ Warm Tips:The temp of the nozzle could reach 200° in seconds, pleasedon't use it for more than 10 minutes at one time.If the temperature of the fuselage increases significantly, please close the heat gun and wait for cooling before using it.Itcan not be usedinindustrial aspects such as disaembly and welding of small iron sheet components and patch integrated circuits.