12V 60W Oil Scavenge Exctor Exchange nsfer Car Motor

12V 60W Oil Scavenge Exctor Exchange nsfer Car Motor

Description:Rated Voltage: DC 12VRated Power: 60WMaximum Preure: Max. 0.8MPAMaximum Flow: 5L/min Diameter: Approx. 4.8cm / 1.89inchLength: Approx. 14.5cm / 5.7inchOutlet size(Dia.*L): Approx. 11mm*140cm/0.43*55inchInlet diameter: Approx. 8mm,6 mm Length: Approx. 100cm/ 39.37inchCable Length: Approx. 30cm / 11.8inchClips Length: Approx. 8cm / 3.15inchMain Color: BlackApplication: Widely used in general industrial equipment, equipment, equipment, shipbuilding, drinks, carpet and floor cleaning, water and water treatment equipment, vehicle cleaning, agritural spraying, zo line preure, air cleaning cooling, coal and metallurgical industriesNote: If you want to connect this to AC power, you will need a power converter.How to use:Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start ing oil.Connect the to the power, run it for a while, and observe whether the inlet and outlet is normal.Open the filler cap,get dipstiout, force the tube into the bottom of the joint, until the tube does not move; then put the inlet from the oil dipstiinto in end (the tube into the bottom of the tank, the bottom concave p, in order to the oil completely); as no oil or ing up very slowly or intermittently, it is generally caused by loose s and fittings. You have to install the s and fittings again.)After oil ing, remove the tube, and then run the for a while, the remaining oil inside the ing clean, or water for a while until the head gets clean.If you have not used it for a time, it may have no suction, then just pour the water in the , and run the for a few minutes until the air is all out.Package Includes:1x Oil 1x 11mm outlet 1x 8mm hose1x 6mm hose