12V Car Electric Turbo rcharger Air Intake Boost Fan w Brushless 40A ESC

90% New Old it shown the photo.Turbine front and baplastic material CAP removable if you don`t want it.Speed: 35000 rpmInput Voltage: DC 12VMaximum current: 24AMaximum power: 380WMaximum thrust: 1200gKV value: 3100Maximum speed: 52000RPM (loud voice)Number of poles: 6Winding connection: Y-type 5-wire and aroundESC voltage: 5VPackage include: Turbine + Brushle 40A ESC(Electronic Speed Control)Notice:Don`t wiring the turbine directly to Power.This have to connected up Driver ESC electronic speed control.Don`t Let the turbine contact with car iron part(because of other iron part also negative electrode "-")This preure increase is very effective. Don't compare it with the cheaper products of the same de. It's definitely not a grade. This manual control motor speed.This kind of modification is more violent, and the wind preure is very high. Suitable for customers who require high performance improvementA 70mm Top Violent rcharging Fan Automobile rcharging Violent Fan Automobile Refitted ing Fan, Special Fan for Automotive Electric TurbineThe diameter of air inlet and outlet is 7cm/7.5cmMotor Length 10cm Motor Material Metal Shell Metal LeafModerate volume and easy installation100% authentic product.Please operate according to the followingoperation mode:a. Power off firstb. Esc switch knob is screwed to the minimum position.C. To connect dc 12 volt battery.StepThe first step is to insert the three- plug into the out position of the . The white line is on the s-pole.There are three rows of arbiry plugs in one row, and the knob is set to the minimum position.The second step is to weld the three rows of motor wires with the three wires adjusted by electricity without difference.After welding, tape should be wrapped to prevent short circuit.The third step is to connect a DC 12 volt power supply to an electrically regulated red connection positive pole and a blaconnection to the negative pole.After power on, the motor will e a sound, stop ringing after a few seconds, then slowly twist the knob of the to start the motor,the normal operation of the wind is from the motor tail discharge, if not to indicate that the motor red, the need to remove two of the motor wires to adjust and then welding,then the motor works properly.If you can follow my instructions carefully, there will be no problem with the product.If you have any questions, please feel free to contact us.