2" 52mm Dual with Alram 2 In 1 Car Water Level Sewage Level Meter Water Temp 9-32V

2022 New 52mm Universal 2 in 1 Dual

Application: Marine Boats/Truck/Bus/Motor Home/Hot Rod/

About the Reading

The device works, with a little delay (about 20-80 seconds ) of changes in the readings. Apparently, it is done in order not to react to the sp of water in the tank.

Feature:

- 52mm diameter Two in One show with easy - Programmable Input Resistance Signal to adapt different /water/temperature r0-190Ω, 0-180Ω, 10-180Ω, 240-33Ω, 240-30Ω- High Resolution View under sunshine- Diameter: 52mm (2inch)- Re polarity protection and anti-foing performance- Working Voltage:12V/24V- Working temperatures: - 40 to 85°C- IP66 Waterproof

GUIDE

1. Cut an Φ52mm (2-1/16") hole in the panel (II) allow a clearance of 55mm (2 3/16"). behind the panel.2. Remove fastening ring (I), insert from front. Tighten (III) using fastening ring ( I)3. Connect cables according to the diagram/label.

Setting Menu:"Unit" "R 1" "R 2"

1.Hold & Pre the on, Power On , the LED screen will show Switch ShowUnit, R1, R22.Unit , Water Level, Sewage Level: %Water temperature: ℃ or ℉3.R1---Configure Top Row Signal RangePre on to switch 000 ~006For example, LED will show 001, which means 0~180, then release the on and wait dial f to complete to save setting

Setting Menu:"Unit" "R 1" "R 2"

1.Hold & Pre the on, Power On , the LED screen will show Switch ShowUnit, R1, R22.Unit , Water Level, Sewage Level: %Water temperature: ℃ or ℉3.R1---Configure Top Row Signal RangePre on to switch 000 ~006For example, LED will show 001, which means 0~180, then release the on and wait dial f to complete to save setting

4.R2---Configure Top Row Signal RangePre on to switch 000 ~006.For example, LED will show "002" , which means 10~180, then release the on and wait dial f to complete to save setting

Warning Set about the :

Level :≤20%Water level : ≤20% Sewage Level : ≥80%: