24 77Ghz Millimeter Wave Blind Spot System BSD Blind Spot inge Change ist 10M 20M M Range

Introduction:

*1. V2: 24Ghz operating frequency and 10-meter range. 1)An object with a relative speed close to the signal range will be warned. 2)70% probability of filtering objects in the thirde. 3)Filter objects with a relative speed of le than 10km/h when . 4)No early warning at the same speed and far away.

*2. V3: 24Ghz operating frequency and 20-meter range. 1)An object with a relative speed close to the signal range will be warned. 2)70% probability of filtering objects in the thirde. 3)Filter objects with a relative speed of le than 10km/h when . 4)No early warning at the same speed and far away.

*3. H3: 77Ghz operating frequency and -meter range. Early warning logic intelligence: (single ) external installation. 1)The thirde is filtered without warning. 2)No early warning at low speed (1-15KM/h). 3)Increase the approach warning m (when the rear vehicle enters the m range from you, the starts to calculate the approach time between two vehicles, and the light will be on when the time is le than 4 seconds. The faster the rear vehicle is, the greater the speed difference is, and the farther the warning distance is (to ensure the safety warning distance). 4)Test the same speed within the signal range (8 meters behind) and away from the vehicle (the same working energy as the vehicle factory)

Function:

*1. Ar ACC is powered on, the system can enter the working state immediately ar envmental adaptation test. When the engine stops, the stops working.

*2. The system is in the Level 1 alarm state, except that the steering light is on, the double fing is on and the car is in R gear.

*3. When the turn signal lamp is turned on, the double fing is on or the car is in R gear, the system is in the Level 2 alarm state.

Level 1 alarm: The alert light is always on.

Level 2 alarm: warning light fes+ sounds.

The alarm range is centered on the back of the car. The ns distance is X, and the longitudinal distance is Y. The left side of the center is negative, and the right side of the center is positive.

Features:

*1. The system is a vehicle auxiliary device, which can help the driver to changees safely when driving.

*2. When two vehicles are in danger of colliding during driving, the warning lamp will light up to remind the driver. If the left/right turn signal lamp is turned on, the will make a sound.

*3. Blind spot starts when the car starts. When you open the door, if there are pedestrians, cars and motorcycles on the side, the system will detect them and give you an accurate alarm.

*4. The blind spot system can distinguish between stationary objects and moving objects. Pedestrians and vehicles in driving state will activate the alarm when they are detected.

*5. When waiting for ffic lights, ar parking, the vehicle behind you is stationary, and the blind spot system does not alarm.

Descrtion:

*1. Applicable Conditions: general (no metal object shall block the )

*2. Operating Frequency Band: 24Ghz/77Ghz

*3. Voltage: 12V

*4. Maximum Power: 5W (maximum)

*5. Operating Temperature: -40°C~+85°C/-40°F~+185°F

*6. Storage Temperature: -40°C~+85°C/-40°F~+185°F

*7. Waterproof: 67K

*8. Range: 0.3m-4m/0.98ft-13.12ft(ns), 0.3m-m/0.98ft - 164ft(rear)

*9. Range Accuracy: ≥96%

*10. Alarm Range: 0.3m-m/0.98ft - 164ft

*11. System Alarm Accuracy: ≥ 96%

*12. Alarm Mode: LED indicator on; LED indicator fes and

Package Includes:

V2: 1 x Angle Ruler, 2 x , 1 x Silica (45ml), Ties, 1 x r's Manual, 1 x , 2 x Warning Light(270mm), 1 x Power Cord, 2 x Warning Light Extension Cable(4meters), 1 x Extendable Cable(6.5meters), 1 x Pack Box

V3: 1 x Angle Ruler, 2 x , 2 x Bracket, Ties, 1 x r's Manual, 1 x , 2 x Warning Light(270mm), 1 x Power Cord, 2 x Warning Light Extension Cable(4meters), 1 x Extendable Cable(6.5meters), 1 x Pack Box

H3: 1 x , 1 x Silica (45ml), Ties, 1 x r's Manual, 1 x , 2 x Warning Light(270mm), 1 x Power Cord, 2 x Warning Light Extension Cable(4meters), 1 x Extendable Cable(6.5meters), 1 x Pack Box

Attention:

*1. Profeional installation is needed.

*2. The installation angle of the will affect the distance and effect. Please install in strict acconce with the instructions.

*3. Light shooting and different displays may ca the color of the objects in the ture to be slightly different from the real objects. The allowable measurement error is+/- 10-30mm.