This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
Shipped from abroad
Free return within 7 days for eligible items.Details
Vast Ocean
86%Seller Score
17 Followers
Shipping speed: Good
Quality Score: Excellent
Customer Rating: Good
New outer rotor brushle motor,
Built in brushle drive circuit,
The motor power is very strong,
The maximum power can reach about 80W,
61mm diameter thiouter rotor,
double ball bearings,
When the motor is powered on, the start is delayed and slow,
Two sets of voltages are required for motor power supply,
One group is powered by 12-24V motor,
One group is 5V control power supply,
The driving operation requires a CLK signal with a duty ratio of 50% of 50hz-1khz,
The motor running shaft looks at itself and runs clockwise.
Note that the motor brake function foot needs to be connected to the negative pole before the motor can be started,
If you are equipped with a signal board, you need to pay attention to this function pin.
Motor nominal voltage 24V,
The rated power is about 80W,
The measured motor can operate from 12-24V,
The motor starts slowly,
12V, no-load 1.3A, maximum no-load speed: 2200 rpm;
24V, no-load 0.45a, maximum no-load speed: 2900 rpm,
The maximum working current under 12V voltage is about 3a and 36W, which can not reach the maximum power,
The maximum power of 80W can only be achieved under 24V power supply,
The measured peak protection current of motor under 24V voltage reaches 7a,
Like the parameter table in the figure below,
The parameter table below is the information searched online and is for reference only.
Weight: 370g
Regulated power supply is required for brushle motor power supply,
Remember the positive and negative of power supply, and make no mistake,
For the introduction of wiring, please refer to the description and definition in the figure below,
Power on after confirming that it is correct,
Connected to the wrong instantaneous burning driver.
About shippingThis product has no ratings yet.
Subscribe to our newsletter
and be the first one to know about our amazing deals!