4-in-1 e Control Duplicator 433MHZ e Control 4 Key ons Garage Gate Door Auto Pair Copy e Garage Door Opener

The e Control Duplicator is the easiest and least expensive way to copy any wirele e, car key, garage door opener, and more!

▶ BENEFITS

This gadget nsfers signals to duplicate your existing e controls so you always have a duplicate e or key available in case you lose the .

The device can clone up to 4 e ons from the same or different allowing you to carry four in one! Each corresponding letter (A, B, C, & D) can open a different e-controlled key.

You can open your garage door and unloyour car by using one e control instead of carrying two keys with you.

The seamle infrared connection is secured and safe to use through data

You can copy any compatible wirele e key and each paword is stored inp>

▶ FEATURES

Easy to copy and done within minute

Portable key-chain design

High frequency 433MHz

▶ SPECIFICATION

Working Voltage: 12V

Code Type: Copy

Working Frequency: 433MHz

e Distance: 50-100m (The sensitivity of the receiver is -100dbm in the open area)

Product Size: 68*16*15mm

Package Includes: 1*Pousbo® 4-in-1 e Control Duplicator

▶ HOW TO USE (very easy)

Clear code: using two fingers, hold two ons at the same time (i.e., A & B or B & C, etc.); the LED will rapidly f 3 times in about 2 seconds; let one of the fingers go (the other finger should stay holding one of the ons), and then use the loose finger to quickly clithree times on the loose on until the LED light fes; then release both ons; then pre any one key of the e control.

When the LED light goes off, it means the clear code is succeful (four keys all empty); if after you pre any on of the e control, the light is still on, it indicates that the code has not been cleared succefully. You need to re-clear, and only by succefully clearing the code can cloning be succeful. You can repeatedly clear and clone the code.

Copy: left hand taking the e control, right hand taking our e control duplicator, and keep two e control as close as poible; pre the first ons of two e controls at the same time; in about 2 seconds, the LED light will f quickly 2 times; after one second, the indicator light keeps fing and let go of your fingers; and then pre the key after succeful pairing, the light keeps on, which means that the first key code on the e control has been copied to the other e control; the same method can be used in turn on the second key, the third key... If the copy is succeful, the e control function is the same as the matching e control.

Restore: When you accidentally clear the copy of the e control code, you can simultaneously pre the copy of the e control of the bottom two keys, LED lights will f quickly, and let go after preing any key. When the light is , this indicates that the code for the e control is restored. Before using our copy e control, please be sure to remove the existing code from the e control.

How to deal with a situation where some of the keys can control, but the rest cannot control? You can use clear and restore operations, the specific operation is as follows:

First clear code;

After clearing the code, copy the unsucceful key again, and there is no need to copy the rest ons;

And then clear the code again;

Restore code; at this time, the keys that were not succefully copied are now covered by new codes, and the keys that were succefully copied are now retained. If there is no copy after the second copy of the keys, repeat the above steps again and again until all keys are succefully copied.

Buy the e Control Duplicator NOW while it is still in stock!

NOTE

Please allow slight measurement deviation due to manual measurement.

Due to the different monitor and light effects, the actual color of the item might be slightly different from the color shown in the pictures.