433MHz DC 12V 1CH Relay Module Receiver EV1527 Wireless e Control Switch for Garage Gate Motor Light Lamp DIY

Relay Receiver Board

Working voltage : DC 12V

Quiescent Current : 97dbm

Support en : 1527 Learning code

RF Operating mode : ASK rheterodyne wireless reception

e operating mode : Momentary Mode / Tole Mode / Latched Mode / Time Delay Mode 5s ,10s ,15s

e control battery:3 V CR2016 on batteries

e prograng

Working mode:

1. Inching mode: press the e controltherelaywill connect, and thenrelease the e controlto disconnect the relay;

2. S-locking mode: press the e controltherelaywill connect, and then press the e controlagainto disconnect the relay;

3. Interlomode: press the e control key A toconnect the relay, and press the e control key B to disconnect relay.

4. Delay mode: press the e controltherelaywill connect, release the e control and start timing. After 5S, 10S and 15S 3 gears, the relay will be automatically closed.

Learning Methods:

1. Inching learning method:

Press the codepairing on on the control panel once, and the LED indicator will f once. After the LED indicatorlit, press the onyou need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

2. S-locking learning method:

Press the codepairing on on the control paneltwice, and the LED indicator will ftwice. After the LED indicatorlit, press the onyou need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

3. Mutual lolearning method:

Press the codepairing on on the control panelthree times, and the LED indicator will fthree times. After the LED indicatorlit, press the onyou need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

4.5S delay learning method:

Press the codepairing on on the control panel four times, and the LED indicator will ffour times. After the LED indicatorlit, press the onyou need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

5. 10S delay learning method:

Press the codepairing on on the control panel five times, and the LED indicator will ffive times. After the LED indicatorlit, press the onyou need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

6. 15S delay learning method:

Press the codepairing on on the control panel six times, and the LED indicator will fsix times. After the LED indicatorlit, press the onyou need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

Clearingmethod:

Press the codepairing on on the control panel eight times,then it will automatically clear all thelearnede controls.After clearing, the e control previously learnedcan no longer beused.