433Mhz DC 12V 20A 4CH Relay Module Receiver EV1527 Wireless e Control Switch 433Mhz for DC Motor DIY

For Receiver Module :

Working Voltage: DC 12V

Product Type: 4 e Control Switch

RF Working Mode: ASK rheterodyne

ReceptionModulation Mode:ASK

Working Mode: Momentary/Tole/Latched, etc.

Matching Mode: ligent Learning Code.

RF Frequency: 433MHz

Receiving Sensitivity: >104dbm

e

Size: 60*30 mm

Frequency: 433.92 MHz

Battery: Including battery

Color: Black

Code: 1527 learning code

Range: about 50-100m in open space

Operation Introduction:

About Working Mode:

1. Momentary/Jole: Press and hold->On; Release->OffKeep pressing one on, the corresponding is working /on; Release your finger is stop/OFF. 4 switchreceiver need 4 on e control nsmitter

2. Tole/S-Lock: Press->On; Press again->Off Press one on for one time, the corresponding is working/on; Press the same on again to stop/OFF. 4 switchreceiver need 4 on e control nsmitter.

3. Latched/Inter-Lock: Press->on; Press other on->OffPress one on for one time, the corresponding is working/on; Press another on is stop/OFFAt the same time, another corresponding works. 4 switch receiver need 4 ons e control nsmitter.

The Setting of Working Mode:

1.Momentary Mode: Pressing the learning key on on the receiver board once LED Indicator on receiver board will signaling simultaneously, then press any of the e on, signaling three times by e& x27;s LED indicator means setting Momentary Mode successfully.

2. Tole Mode: Pressing two times the learning key on on the receiver board twiceLED Indicator on receiver board will signaling simultaneously,then press any of the e on , signaling three times by e& x27;s LED means setting Tole Mode successfully.

3.Latched Mode: Pressing the learning key on on the receiver board three times LED Indicator on receiver board will signaling simultaneously, then press first e on, follow on second e on, signaling three times by e& x27;s LED indicator means setting Latching Mode successfully first on stands for on, second on stands for off .

4.2CH Momentary + 2CH Tole: Pressing the learning key on on the receiver board four timesLED Indicator on receiver board will signaling simultaneously,then press any of the e on , signaling three times by e& x27;s LED indicator means setting successfully.

5. 2CH Momentary + 2CH Latched: Pressing the learning key on on the receiver board five timesLED Indicator on receiver board will signaling simultaneously, then press any of the e on, signaling three times by e& x27;s LED indicator means setting successfully .

6. 2CH Tole + 2CH Latched: Pressing the learning key on on the receiver board six timesLED Indicator on receiver board will signaling simultaneously, then press any of the e on, signaling three times by e& x27;s LED indicator means setting successfully.

7. 2CH Latching + 2CH Latched: Pressing the learning key on on the receiver board seven timesLED Indicator on receiver board will signaling simultaneously, then press any of the e on, signaling three times by e& x27;s LED indicator means setting successfully.

8. Deleting Existing e Controls Data: Pressing the learning key on on the receiver board eight times, the LED Indicator on receiver board will f for eight times, it means that the existing e controls are deleted successfully.