433Mhz DC 12V Motor 10A CW CCW Linear Actuator ControllerWith Limit e Control Switch For Motor Linear Actuator

12V DC motor forward and re e control switch rectable door curtain electric push rod wireless e control

12V DC motor forward and re controller with limit function using two 10A relays

Use the safe range within 5A It is recommended that the motor be used within 60 watts to be safer


The initial state is power off, the motor stops, and the initial state is maintained after power off


ligent learning code matching, equipped with s-locking, interlocking and non-locking function conversion slots inside

This model adds a manual control lead pin, which can be connected to a manual switch.

To switch modes, please switch off the power, otherwise it will be invalid

When you choose not to install the limit, you can switch to non-locking use, and the motor can move as much as you want

accomplish.

When you choose to install the limit position, you can switch to interlocking use, and you can press it wherever you want to move

stop key.


1. Operating voltage: DC 9V to 12V

2. Standby current: About 10mA

3. Operating current: About 35mA

4. Maximum load current: Less than 10A

Less than 60 watts of equipment

5. Operating frequency: 433mhz

6. Size: 3.96in*1.77in*1.14in

7. receiver sensitivity: -105dBm

8. Function: Limit & external manual on

How to wire to your external manual on if you need
Forward ---------R & COM
Re ----------L& COM
Stop---------------Stop & COM

9. Initial state OFF, Suddenly the power was cut off, then comes back, the state is still OFF, you need to manually turn it ON

10. Out state: Momentary Latched Adjusted by the jumper on the receiver,
We ship default as Latched, if you need to use Momentary to change the jumper on the receiver,

11. Momentary---------- Jumper on "1&2" pin

12. Latched----------- Jumper on "2&3" pin

13. Momentary -------------
Press "Up" on, the motor forward, release is stop.
Press "Down" on, the motor re, release is stop.

Latched----------------
Press on "Up", the motor forward, press on "Stop" is stop.
Press on "Down", the motor re, press on "Stop" is stop.

14. When the receiver output state is "Latched", we have set it 0.5s time delay for forward and re, it is the protection function.

15. We have made nsmitter and receiver work together and test it before shipping, when you get it, you don& x27;t need to do anything, just install it.

16. Learn code
1. Press the learning on on the receiver for 1 time, the learning indicator ON, then press the nsmitter on up for 1 time first on default for forward, the learning indicator f 2 times and ON, It mean the first on learning successful.

2. Then press the nsmitter on down for 1 time second on default for re, the learning indicator f 2 times and ON, It mean the second on learning Successfully

3. Then press the nsmitter on stop for 1 time third on default for stop, the learning indicator f 2 times and ON, It mean the third on learning successfully.

4. Then press the nsmitter on stop for 1 time again, the learning indicator will f 2 times and OFF, It mean all on learning Successful.

17. Press the learning on on the receiver for 5s, the learning indicator will f 3 times and OFF, It mean all the nsmitter code in the receiver have been deleted.