433Mhz e Control Switch AC220V 30A Hign Power On off e Control nsmitter for Water Motor LED/Electric Appliance

Specifications Of The nsmitter

e control nsmitter

Operating voltage:DC12V23A/12 battery x1

nsmitting frequency:433MHZ

En Type: Fixed code

Receiver sensitivity:>-105dB

nsmission distance :100MOpen field

Size:approx 66*28*29mm

Specifications Of The Receiver:

Operating voltage:AC 110V-240V

Output voltage = Operating voltage

Operating frequency:433MHzSame withe control

En Type:learning code

Rated contact current of relay:15A/240VAC,15A110VAC Please notice that :Although the relay is

marked 30A 240VAC.The 30A is for the peak currentof your load. The rated current of your load should lessthan 15A

Box size:Approx 65x45x28m

Operation Introduction:

About Working Mode:

Momentary: Press the e on, the relayconnects,release the e on. the relaydisconnects.

Tole: Press once the e on, the relayconnects,press the e on twice, the relaydisconnects.

Latching:Press the e on A, the relayconnects,press the e on B, the relaydisconnect.

Clearing the Code:

Press the Learning on on the receivers for 8times, the codes will be cleaned.

After cleaning the code, all the e control cannotwork any more.

Learning the Code:Momentary

Press the learning key on the receiver once time, itcomes into momentary setting mode.

Wait for a moment, the LED will be off ,it comes intolearning state.

Push the e on, LED indicator on the receiverboard wil f then come off.

After 3 seconds, the LED indicator will be on againlearning successfully.

Learning the Code: Tole

Press the learning key on the receiver twice time, itcomes into tole setting mode.

Wait for a moment, the LED will be off ,it comes intolearning state.

Press the e on, LED indicator on the receiverboard will f then come off.

After 3 seconds, the LED indicator will be on again,learning successfully.

Learning the Code: Latching

Note: When you choose for latching mode, in order tolearn more e control, you need to learn twodifferent on, the first time learning is for ON, thesecond time learning for OFF.

For example: on A=ON,on B = OFF

Press the learning key on the receiver tre time, itcomes into latching mode.

Wait for a moment, the LED indicator on the receiverboard will f then come off.

Press the e on A. LED f for 5 times.

Press the e on B.LED f for 5 times

After 3 seconds, the LED indicator will be on againlearning successfully.

A = ON, B = OFF

About Delay:

1.Learning method with a 5-second delay

Press the controller learning on four times, theindicator light fes four times and then press thee control to send a code, the receiver indicatorfes three times and then the learning is successfulthen press the e control to send the code, therelay will automatically disconnect after 5 seconds ofclosing.

2.Learning method with a 10-second delay:

Press the controller learning on five times, theindicator light fes five times and then press thee contro to send the code,the receiver indicatorfes three times and then the learning is successfuthen press the e contro to send the code.andthe relay will automatically disconnect after 10seconds

3.Learning method with 15 seconds delay:

Press the controller learning on six times, theindicator light fes six times and then press thee contro to send a code.the receiver indicatorfes three times and then the learning is successful.then press the e contro to send the code.andthe relay will automatically disconnect after 15 secondsof closing.