45W MX-P50M HF Power Amplifier for FT-817 ICOM IC-703 Elecraft KX3 QRP FT-818 G90 G90S G1M X5105

HF power amplifier, for QRP nsceiver, Improve signal. Can be used both as a base and mobileunit,Extremely Small Compact and lightweight , Full integration with the FT-817 using the supplied interface cable.The amplifier incorporates various protection circuits such as high VOLTAGE,front mounted LED display.This amplifier can be succefully used with other QRP rigs such as the ICOM IC-703(and Elecraft KX3).YAESU FT-817ND Quick operating manual:Connect power cord to DC power supplier, Red to "+", Black to" -"Connect ACC cable to FT-817 ACC and ampAdjustment "BAND ADJ" on,Select the band.Connect to amp "ANT" and "input" from FT-817 out. Note that the you used that should well tuned, the SWR should le than 1:1.5Open the power on both power supplier and AMP. The power indicate on.Power on FT-817, the band indicate on Amp shoule be on.Pre PTT, the TX indicate on Amp should be on.Notice! If working on FM or SSTV for long operating time, should lower the output power on FT-817,say 2.5W or 1W.Other QRP nsceiver operating manual:Connect acc cable to nsceiver PTT-TX and amplifier,ACC green to"GND",RED TO"TX-PTT",the radio "TX-PTT"view manual.SpecificationsFrequency Band: 80m 400m-17m 15m-10mOperating Modes: SSB CW AM, RTTY and FM-Reduced duty cycleRf input: 5WOut power: 45WBand mode: ManualPower requirement: 13.8V 8A, RED "+" BLACK"-"Cooling method:paive air cooling connector: SO-239 50Colour:silverMaterial:MetalSize:155 x 100 x 35mmPackage Contents:1 * MX-P50M1 * Power cord1 * PTT Control cable for FT-817 818Only the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.