50cm x 3M VLT 70% Light Cyan Nano Ceramics Foils Car Side Window Tints Solar Film Sun Protection High Heat BloIR 60% UV 99%

Read before you buy!!!--- ** If you see any creases from unrolling the roll, this WOULD NOT affect the item when you apply to your car! We are not responsible for creases from unrolling the roll because that is the nature of the roll when you unroll the item or when the item rolled for too (think about when you fold your clothes for a time, it will have crease/wrinkles)**Tinted windows are becoming increasingly popular with drivers everywhere - and whether you want them for the additional privacy they offer, the protection they give from blazing heat and harmful UV rays, or simply the sleek, ed look they give to your car, it's always an option to tint your side windows yours. Although tinting car windows can be a diffit task for beginners, the following steps will help facilitate the proce, and allow you to give your vehicle a fresh new look.Film tinting is a very popular method for tinting car windows after they've been purchased. With this method, the window gla first needs to be specially treated, before a thin polymer film is carefully attached to the gla. This is probably the least expensive form of window tinting, and some installers believe that the film can even limit the poibility of the windows shattering upon collision. However, film tinting is not permanent and it will need to be repd every five years or so to prevent cracking, peeling, and bubbling .Consider having your film tint applied by a profeional installer if you have never applied film tint before. This way, you can avoid the appearance of bubbles or damage to the film.INSTRUCTIONS:Step 1.Measure the size of the car gla, the length and width of each one plus more than 3 cm, so as not to install the film  does not conform to size.Step 2.A clean window is vital a succeful factor,so keep window or gla clean.Step 3. Remove the nsparent  backing sheet from Film .Cover the surface of the whole film with water.This helps to prevent the film becoming tangled and sticking to its.Step 4. Piyour film up  and apply to your window( Please E SURE you have removed the backing sheet before you apply to the  window and  gla). and water on film and gla can e it slide to the correct position.Step 5. And repeat  scraper proce,using the scraper to push any remaining moisture or bubbles to the edge of the window.Much easier than Wall Decals.Step 6. Finally use the paper towels to dry the window and the frame,g carefully not to lift the film at the edges or corners.NOTE:1.Before installing , please chethe film carefully,if you find any creases,tears or other defects,please contact us immediately for ace.Don’t remove the backing sheet or attempt to fit your film .We are unable to accept returns or provide s if installation has been attempted.2.If you want other size, please contact us .

Specification:

1.Material: PET2.Size:0.5*3. Visible light nsmittance rate:70%4.UV protection :99%5. Heat Insulation:60%6.Thickne: 2MiL