describe:

1.This is a fan that uses thermal power as an energy source to cirate the hot air from the wood-ing firep. There is a module on the fan that acts as a small to drive the fan's motor. Electric current is generated when this module experiences a heat difference between the top and bottom surfaces. The bottom of the fan heats the bottom surface of the module, while the top of the module is kept cool by the fan's top fins.

2.That is, as as it is pd on top of the ing stove, it will absorb heat to drive the fan to rotate, thereby blowing the hot air above the wood-ing firep directly to the living area, increasing the air ciration in the room and improving the heating efficiency of the stove .

3.The rotation speed of the fan varies depending on the temperature of the wood-ing stove. The higher the stove temperature, the faster the rotation speed. When the furnace temperature is so low that the fire goes out, the rotation speed slows down until it stops rotating.

Features:

1. Save , fans distribute heat from the stove to provide better efficiency;

2. S-generating - no plug - no battery, no need for any battery or power source;

3. Quiet operation;

4. S-start, adjust speed and stop;

5. Simple and stylish design.

Specification:

Name: Firep Fan

Material: Alumina

Air volume: 180-210

Leaves: 6 leaves

Wind speed: 800-1100rpm

Noise: ≦35dB

Working temperature: 60-350°c

Product size: 180*100*190mm

Color: 8 colors: black, gold, silver, iron gray, red, bronze, rose red, blue

1. P the stove fan on a smooth, flat surface on the stove top, near the side or baof the chimney.

2. The furnace fan is designed for independent stoves, and the surface temperature of the furnace is between 65℃-C 350℃. Temperatures above this range may damage the fan and set.

Product Care:

1. Please read the user manual before using the fan.

2. Please always use the fan on the package.

3. Before using the fan, please chewhether the fan is damaged. If the fan is damaged during nsportation, please do not install or use the fan.

4. When the fan is working normally, please keep children away from the fan.

5. Please do not touch any part of the fan when the fan is working, if you want to move the fan, please wear protective .

6. When the temperature exceeds 300 degrees, the bimetal thermal insulation device at the bottom of the fan will automatically bend and tilt to protect it.

7. Please use this product with a free-standing stove, not a built-in stove or other insulated top designs.

8. When the temperature is higher than 250 degrees, lift our fan to the upper position of the heat insulation board, so that the fan can reduce heat absorption and effectively protect the fan. Because the open flame temperature of this type of furnace is too high, it needs to be used with a heat shield. At the same time, it is recommended to use a to monitor the temperature of the furnace.

Package list：

Firep Fan x 1pc