85mm Multifunctional 12000RPM + meter+ Level+ with Gear 299KMH MPH Speed Meter 12V 24V

Install the

a.P the motorcycle on a level and secure area. Disconnect the battery.b.Refer to the appropriate factory service manual and remove the OEM meter.c.Mount the new meter in the desired location.d.Locate and route the orange, green and either one of the blawires exiting from the center of the rear of the to the existing OEM meter r wiring. You may extend or shorten the wires as needed for your application.e.Securely fasten the , preferably outdoors (or inside front windscreen) so that it has a clear view of the sky to piup signals. Connect the cable to socket on the . Do not cut cable.f.After turning power on, allow the to sample signal for 1 minute.g.All data is for reference only and should not be trusted as sole navigation source.

Menu：, Unit, odo, oiL

Pre and hold the baon, then power on.The LCD will keep switching & showing “, Unit, odo, oiL” every 1 second.Choose the target menu, release on to enter setting.1.“”: Set the engine speed RPM Ratio, unit: /rpm, range: 0.5-655.3

How to confirm RPM Ratio?

a.If your r is installed on the flying wheel panel, the RPM ratio is equal to the number of gears of the engine.b.If the speed signal takes from W-Terminal of Alternator, the RPM ratio is equal to the half of the number of poles.Normal RPM Ratio for Reference:c.If you cannot find W-terminal of Alternator, you will need order separately our GR01 RPM r adapter to get RPM signal, which just need cro around the ignition cable.2.“ odo”（Set Total ）After selecting “odo”, the LCD will show for example “5000” (5000 km) , pre the on to set the fing di from 0 to 999999 to set the target value.3.“ Unit”（Set Unit: km/h, mph）LCD will switch show km/h, mph .Then release on, and wait for menu to complete fing.4.“oiL”(Set Signal)LCD will show“o00002”（ range 10~180Ω）.Pre on to set target range depends on Table ARelease on and wait for menu to complete fing.Table A5. & Trip Power on the meter, and Pre to reset the Trip to Zero.

Please noted: After setting, you should disconnect both Power+ and GND, and then re-power on, then it will save the setting. If you just cut Power +, then it’ll not work properly.