AC 110V 220V 30A Relay Wireless RF e Control Switch System RF 433Mhz nsmitter On Off for Water s Ceiling LED Lamp

Specifications:

e control nsmitter

Operating voltage: DC12V 23A/12V battery x1

nsmitting frequency: 433MHz

En Type: Fixed code

Receiver sensitivity: > -105dB

nsmission distance : 100M Open field

Size: approx 55*28*10mm

Receiver board

Operating voltage: AC 110V - 240V

Output voltage = Operating voltage

Operating frequency: 433MHzSame with e control

En Type: learning codeyou can buy ex 315MHz e controllers for this receiver

Rated contact current of relay: 15A/240VAC, 15A/110VAC Please notice that : Although the relay is marked 30A 240VAC. The 30A is for the peak current of your load. The rated current of your load should less than 15A

Box size: approx 65 x 45 x 28mm

Instructions:

1. Jog: The e control is controlled by a on. After pressing the on, the relay is closed, and when the on is released, the relay is disconnected.

2. S-locking: The e control is controlled by a on. Press the on once to pull in the relay, and press it again to disconnect.

3. Interlock: The e control is controlled by two ons. Press the A on to close the relay, and press the B on to disconnect.

4. Delay: After the pairing is successful, the relay will automatically disconnect after 5 seconds/10 seconds/15 seconds/20 seconds.

Learn to code:

1. Jog learning method:

Press the learning on of the controller once, the indicator light fes quickly and it is in the learning state, and then press any on of the e control you want to learn to send a code. At this time, the indicator light fes three times and goes out, and the code matching is completed.

2. S-locking learning method:

Press the controller learning on twice, the indicator light fes twice quickly in the learning state, and then press any on you want to learn on the e control to send a code. At this time, the indicator light fes three times and goes out, and the code matching is completed.

3. Interlocking learning method:

Press the controller learning on three times, the indicator light fes three times quickly in the learning state, at this time press the e control A on, the indicator light fes three times, and then press the e control B on again, the indicator fes three times and goes out, and the code matching is completed .

4. Learning method with a 5-second delay:

Press the controller learning on four times, the indicator light fes four times and then press the e control to send a code, the receiver indicator fes three times and then the learning is successful, then press the e control to send the code, the relay will automatically disconnect after 5 seconds of closing.

5. Learning method with a 10-second delay:

Press the controller learning on five times, the indicator light fes five times and then press the e control to send the code, the receiver indicator fes three times and then the learning is successful, then press the e control to send the code, and the relay will automatically disconnect after 10 seconds.

6. Learning method with 15 seconds delay:

Press the controller learning on six times, the indicator light fes six times and then press the e control to send a code, the receiver indicator fes three times and then the learning is successful, then press the e control to send the code, and the relay will automatically disconnect after 15 seconds of closing.

7. Learning method with a delay of 20 seconds:

Press the controller learning on seven times, the indicator light fes seven times and then press the e control to send the code, the receiver indicator fes three times and then the learning is successful, then press the e control to send the code, and the relay will automatically turn off after g closed for 20 seconds.

Clear data:

Press and hold the learning on for 8 seconds without letting go, the indicator light fes once until the receiver indicator fes 6 times quickly, the code clearing is successful