AUTOFAB Turbocharger Turbine Exhaust SS CHRA Clamp V Band For Toyota CT20 CT26 Turbo 95mm Flange AF-HFQ950

Youarebuyingon100%of:

AUTOFAB Turbocharger Turbine Exhaust SS CHRA Clamp V Band For Toyota CT20 CT26 Turbo 95mm Flange AF-HFQ950

Contents:1 x Turbine Housing Clamp (includes fixing bolt and nut)Specification:Torque Rating: 5NMOutside Diameter: &os;109mmAembled (Flange)Size: &os;95mmFlange Clamping Thickne: 16mmApplication:For Mitsubishi TD07 TurboFor TOYOTA CT20 CT26 TurboFor T51R, T04Z, AX75F- Clamp between and turbine housing (amongst others) with an 95mm V-band flange.This clamp is used to clamp up the V-band style flanges of the bearing housing and the turbine housing flanges of the CT20/CT26 turbochargers, as well as many other applications with the below dimensions:These clamps are complete and include fixing bolt and nut.Correct fitting of a V-band clamp is vital for correct operation and to ensure you do not suffer premature fai.CORRECT TIGHTENING OF YOUR V-BAND CLAMP:V-Band clamps are NOT tightened exceively. They are designed to pinch the mating flanges together whilst allowing movement through expansion and ion. Over-tightening can damage clamps, flanges and, in the worst case scenario, work.To mount your V-Band clamp, put mating flanges together and fit clamp. Tighten clamp to a torque setting of 3.5 Newton Metres (NM). Then, using a rubber mallet, tap around the mating flanges to allow the joints to fully centre and sit without any unequal load. Then increase torque to its final torque setting of 5 Newton Metres (NM).Further tapping with a rubber mallet to remove any uneven load from the clamp or flange is beneficial, whilst checking the torque setting stays at its rating of 5 Newton Metres (NM).

All it are unle stated otherwise on the listing. We sell DIY (Do It Yours) It with a few exceptions. We take no responsibility in teaching you how to install. Profeional installation is strongly recommended.