Autostart one Start Stop engine on with LoIgnition Entry engine Starter alarm system car accessories

Auto Car Push on Start Stop engine with LoIgnition Switch Keyle Entry System engine Starter alarm system

Notice:

1. This model is working for 12v low and medium cla cars only, can not work for high cla cars of US and European.

2. If your car has chip immobilizer, you need to buy bypa or use other way to avoid chip immobilizer.

3 For opening trunk function,please add relay for your car.

This is a simple and easy use Car Alarm with Finger Engine Start Push on Start Stop and nsponder Immobilizer. Car Engine Push Starter is easy to install and use, can start or stop your car much easier and keep your car safe at the same time. This item is only work with DC12V cars at the moment.Features:Push on engine start.Telecontrol starting functionAutomatically lothe host after stalling 35 seconds.10 minutes timing flameout function after telecontrol starting.Telecontrol starting safe handbrake function.Automatic locking the door function after telecontrol starting.Open acoustics and dasard function. engine lock.Immobilizer, with warded locard anti-theft function, the system will enter arming mode after 15 seconds automatically when car is stopped.In arming mode, when the responder gets close to (about 2 - 5cm) the wire circle, the system will sound Bi Bi, which indicates the system is disarm.Can be matched your car alarm system or keyle entry system.Can be used in all kind of cars.Easy to install and to detach.ble,PortableFunctions: Improve driving safetyMaterial: ABS,Electronic Components,MetalColor: BlackQ & A :

1.How to find the ACC wire?

Please rearrange the 6P cable, after you twist the key to the first gear position (you can listen to music at this time), measure the line that has electricity on your car is the ACC line.

2. For your 6p cable, but my car is only 5p. what can i do ?

If your car is a 5P line, the right connection is normally 1 power line, 1 ACC line, 2 ON lines, and 1 start line. If you didn't follow this step, it means you got wrong installation. pls recheit again. and pls remember 2 ON lines need to distinguish which is ON1 line and which is ON2 line. If the two ON lines are always charged at the time of startup, you need to connect the two ON lines in parallel.

3. How to tell the wire ON1 and ON2?

If you test these two ON lines at startup, one of the two that always has power is the ON1 line. And If the other one has instant power is the ON2 wire.

Package Contents:1 x Car Engine Push Starter Host,1 x Push Start Stop on (1m Cable Length),1 x r Ring (1.2m Cable Length),2 x Key,2 x Wire (0.6m / 1m),1 x English User Manual