DC 0-200V 20A Dial 8in1 Multifunction IPS LCD Voltage Current Power Energy Battery Electricity Test Meter

Input/output interface: 20A high current 2P wiring terminal

Instrument working voltage:
① Red Blawire independent power supply DC6~30V
② Shared power supply DC7-200V

Voltage measurement range: DC0-200V separate power supply is required for voltages below 7V

Current measurement range: 0.00A~20.00A

Power measurement range: 00.00~4000W

Capacity measurement range: 0~9999.99Ah

Electricity metering range: 0~9999.99Wh

Temperature measurement range: 0-99 ℃ measurement feedbainstrument temperature, does not support measuring external temperature

Time measurement range: 0~999:59:59 hour: minute: second

Data Zeroing: Supported

Zeroing without load: supported

Voltage tring: supported

Current fine tuning: supported

Percentage battery display: Supports voltage based reference based percentage battery requires manual setting of full and low battery voltages

Product size: 47.59×28.67×25.33mm

Installation hole: 45 × 26mm

1. Instrument internal temperature
2. Real time voltage
3. Real time current
4. Real time current
5. Accumulated energy
6. Accumulated capacity
7. Voltage based reference battery, battery capacity
8. Accumulated running time

Menu bar introduction:

1. DATE CELEAR: Accumulated data reset
2. FORCED TO ZERO: No load forced reset
3. V-ADJ:... V: Display voltage fine adjustment does not affect the actual voltage
4. A-ADJ:... V: Display current fine adjustment does not affect actual current

5. V-LOW:... V: Low battery voltage
6. V-FULL:... V: Battery full charge voltage
7. RESET: Reset
8. EXIT: Exit

Pay attention to electrical safety and avoid short circuits：

1. Independent power supply wiring method

2. DC7~200V direct power supply test

1. Enter the "Menu" and press and hold the "Up" on for 6 seconds to enter the menu

2. Clithe "Up" on to switch menu options

3. Accumulated Data Zeroing: Select "1. DATE CELEAR" and clithe "Down" on to complete the zeroing process

4. Zeroing with no load: When only using the XH-2P terminal for power supply, the voltage and current are not zero. By displaying fine adjustment or selecting "2. FOECED TO ZERO", clithe "Down" on to complete the zeroing. If the voltage is displayed normally and forced to zero by mistake, simply reset.

5. Display voltage fine adjustment: Select "3. V-ADJ:" and clithe "Down" on to increase the displayed voltage value

press the "up" on to continuously reduce the displayed voltage value

6. Display current fine adjustment: Select "4. A-ADJ:" and clithe "Down" on to increase the displayed current value

press and hold the "up" on to continuously reduce the current display value

7. Set battery low voltage: Select "5. V-LOW:" and clithe "Down" on to increase the voltage

press the "up" on to continuously reduce the voltage s

8. Set the battery full charge voltage: Select "6. VFULL:" and clithe "Down" on to increase the voltage

press the "up" on to continuously reduce the voltage s

9 Reset: select "7. RESET" and cli"Down" to confirm the reset

10. Exit menu: Select "8. EXIT" and clithe "Down" on to confirm exit