body { font-size: 75%; color: #000; font-family: Open Sans,Arial,Heetica,sans-senif,SimSun,"宋体"; line-height: 1.3; } dl { margin: 0px; width: 480px; float: left; } dt { width: 100px; height: 15px; float: left; } dd { width: 240px; height: 15px; float: left; } dl dt { margin: 0px; line-height: 22px; color: #474747; font-size: 14px; font-family: tahoma; } #product-desc { width: 100%; height: 209px; } #descrtion { width: 100%; height: 50%; } #details { width: 100%; height: 50%; } .ui-box-title { height: 30px; font-size: 15px; font-family: tahoma; font-weight: bold; background-color: #ddd; text-anchor: inherit; padding-top: 8px; margin: 0px; } .ui-box-body { margin: 0px; } #tbspecifics { border-right: 1px solid black; border-bottom: 1px solid black; } #tbspecifics tr { height: 30px; } #tbspecifics td { width: 100px; border-left: 1px solid black; border-top: 1px solid black; } DC 0-100V LED Dial Alarm Battery Indicator 5V 12V 24V Voltage Meter Over Charge Wiring instructions:As a two-wire meter application, please send a short circuit board R1, connected to the inputs of the input voltage can be displayed. (When using two-wire measuring range do not exceed 30V)As a three-line header using the R1 plate off the table, the ground and power supply voltage connection 4-30V power supply for the header. Indirect ground voltage to be measured and the test voltage input. (Two to the board pads is the same, can according to the actual wiring by one or two will do) Adjust panel potentiometer can display the value of prospective effect.5PIN pin for the expansion of output, K1, K2 for the onboard external key switch lead, as do key-board, the two PIN via an external on, the on functions with the same function on panel. as the lower limit alarm output, output low when below the set value. HV upper limit alarm output, the output is higher than the upper limit set at the low value., HV outputs a control signal for driving the driver circuit, please add lights, or relay other loads.Upper and lower limit setting method: two keys are preed, the red light (HV) is lit, pre the + or - key to set the desired alarm limit voltage value. And then preing both ons simultaneously, yellow () is lit, pre the + or - key to set the lower limit alarm voltage required. And then preing both ons simultaneously to exit the setting.Supply voltage: 4-30VMeasuring range: 0-100VUpper/Lower limit setting range: 0.1-99.9VUpper/Lower limit output mode: on set range will output high level,otherwise output low level.Minimum resolution: 0.1efresh rate: 300mS/timesOperating temperature: -40 to +85°Input re polarity protection: YESInstallation: 2pcs 2mm screwsSize: 29x23x10mm(LxWxH)Applications:DIY power supply, as the voltage display.Voltage ing.The device overvoltage or undervoltage alarm, or overvoltage or undervoltage protection.Battery over-discharge protection.To be more application you develop.Kindly Note:When applying two-wire, the measurement range and of supply is the same, so do not exceed 30V measurements. When measuring voltage exceeds 30V, with a three-wire!Colour: as shownMaterial: plastic+metalPackage Contents:1 * LED Dial AlarOnly the above package content, other products are not included.Note: Light shooting and different displays may ca the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.