Digital TV Aerial,Tv Antenna,Aerial Tv+ Tv Guard

Product details

Digital receiver antenna This antenna is UHF AND VHF signal receive that help your decoder or your digital TV 

just connect the antenna to the pole and position it facing the mask signal distributor then connect to the decoder or digital and once the signal if scanned you are ready to receive digital signal clearly 

The TV guard is an overvoltage protection device rated at 5 Amps. The TV guard will disconnect if the mains go above the upper limit and re-connect automatically after the supply returning and remaining below the upper limit for the duration of the wait time.

PLEASE READ CAREFULLY1. Make sure that your load does not exceed the rating of the TV guard which is 5 AMPS. If this is exceeded, the TV guard may be damaged, and the warranty will be void.2. Plug the TV guard into the mains and plug your appliance into the TV guard.3. Do not connect more than one appliance to the TV guard.4. On first switching on, the red LED will indicate and there will be no output while the TV guard monitors the mains. If the mains level is acceptable, the Yellow LED is lit indicating that the TV guard is in wait mode.  At the end of the wait time (30 seconds), and if the supply is below the upper limit, the green LED goes on and the load is connected.5. It is recommended that the TV guard is kept switched on, and the appliance switched on and off as required, to prevent activating the time delay every time the appliance is switched on.

Maximum power 5 amps Nominal voltage 230VOver-voltage disconnect 265VUnder-voltage disconnect 180VSpike protection 160JMains spike response time Less than 10nsMains spike discharge current 6.5kAWait Time  30 second sIdeal For TV, Video, Hi-Fi, PABX, Fax machines