DIY Leather Craft Edge Skiving Machine Leather Splitter Skiver Peeler For Craft

Specifications
: Silver
Material: Aluminum
Size: 165x145x118mm/6.5*5.7*4.6 inch
Suitable For: Leather skiving

Features
- Upgrade folder for quick replacement mode, change in one step.
- Upgraded stainless steel wheel nylon wheel, no longer worried about damage.
-Flexibleas long as there is a small piece of flat work surface can be used.
-easy installation, all the parts after computer work planning, laser , with precision.
-The use of energy, through the reasonable design of part Angle coordinate
-Maintenance easy, the whole machine adopts aluminum bracket, stainless steel screws,
stainless steel holder, don't have to worry about the rust problem.The most commonly
used double-sided , tool and three holes most of the industry.

Installation step
1. Put into built-screw nut,and the marbles of screw nut is inside.
2. Install rectangular connectors
3. Connect the two thick aluminum
4. Connect the two thin aluminum
5. Screwed into the screw can be fixed
6. Install the rectangular connectors
7. Connect the beams and columns
8. Install Loading bay
9. Install the stainless steel round,it recommended tightening the screws and non-rotating wheel to prevent slipping and hurt fingers;If you want to rotate feeding,just loose screws
10. Use the longest screws fix the Loading bay
11. Install the and screw with a hexagonal wrench
12. Installed the semicircle base
13. Use G clamp fix on the machine table

Note
1. Before use pls make sure that all screws are tightened and Aluminum will not shift and shake when we use force;Machine and work surface using G clamp to fix;Vertical and horizontal of aluminum is in good condition.
2. The peak mouth of and the surface of stainless steel round keep parallel before use
3. Viewed from the side,the peak mouth of and the centerline of the wheel apart about 3mm because too far back lead to the leather get stuck and can't pull them
4. clamp must tighten with a screwdriver and wrench.

Packing Included
4 x bracket
1 x semicircle measuring tape
8 x Retention tab
5 x plastic cover
15 x screws
2 x wrench
1 x screwdriver
1 x G Clamp
1x
1 x Operating Instructions







a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a