es EL-50448 TPMS OEC-T5 Tire Presure Monitor r EL 50448 TPMS For G-M/Opel Reset Tool EL50448 Mechanical Free Ship

Please Note :

For certain vehicles equipped with a Tire Preure Monitoring (TPM) system, a "r Re-Learn Procedure" must be performed after tire rotations, e Control Door LoReceiver Module repment or Tire Preure r repment. This re-learn procedure can be performed by using special tool 50448

Descriptions:

Most of For G.M vehicles equipped with a 315 or 433 MHz (TPMS) Tire Preure Monitoring system, a "r Re-Learn Procedure" must be performed after tire rotations, e Control Door LoReceiver Module repment or Tire Preure r repment. This re-learn procedure can be performed by using EL-50448 special tire preure tool. EL-50448 works on 2014 For G.M models too.

Introduction :

1.The tire preure r on models in & after 2012 can be read, only with some specified tools.

2.Before tire preure monitoring system works normally properly, the body control module will record ID information of each position in the tire preure r.

3.Please refer to the specific methods as follows:

Step 1 - Enter leaning mode

-Set the gearshift lever to "P"

-Put the ignition switch to "ON"

-Enter the interface of tire preure display by DIC

-DIC shows "Pre Set / Ctrl to re-learn"

-Pre "Set / Ctrl"

-The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode

Step 2 - Read tire preure r information

-Start from the front-left wheel,

-e the J-46079 or Tool EL-50448 up against the valve core position & close to the rim of the -tire sidewall

-El-50448 tire preure tool starts by the start switch

-Succeful to read the tire preure r information when the horn bleeps once

Step 3 - Same method to read other tire preure information

Follow the instuction above to read tire puure of the front-right, rear-right, rear-left wheels.

Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.

Car List: