This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
Shipped from abroad
Free return within 7 days for eligible items.Details
CharacterL
90%Seller Score
25 Followers
Quality Score: Excellent
Customer Rating: Good
This moduel is an USB adpater/ for ESP8266 moduels of type ESP-01; It is conveniently fitted with a 2X4; 2.54mm female header to plug the ESP01; (according to illustration ture 2) and configure or run it right away; A large 1000μf cap will help getting a steady 5.0V VCC from the USB bus and and jumper (on the right of the 2x4P header)(we don't offer any jumper!!!!) will help configuring the GPIO0 line according needs. The module is based on the USB-UART bridget CH340 from WCH which is compatible with all platforms. Note: for an usage with Arduino ESP8266 platform and for Arduino IDE it is neceary to switch manually the GPlO0 state for working mode, in order to get a fully automatic upload it is most likely poible, for a very limited effort, to aign an unused control line from CH340 to driver the GPIO0 line; (probably at the cost of a neceary logic inversion), refer to the CH340 datasheet and most ant to the NodeMCU V0.9 which use the CH340 and already implementsthis solution, the schematic is open source and easily available.
About shping
This product has no ratings yet.
Subscribe to our newsletter
and be the first one to know about our amazing deals!