EU LCD Display Heat gun Thermoregulator hot air gun for Shrink wrapping station construction hair dryer plastic welder

Note: there are some color differences between the product physical and the picture,Product featuresone Grille air outlet design, uniform air supply, strong and powerfultwo Double heating wire, overload protection, rapid temperature rise, not afr of overloadthree PP + GF30 body shell, more heat insulation, anti falling and anti scratchingfour Two speed wind speed regulating switch and steple temperature regulating knob are designed to adjust the temperature according to their own needsfive 365 high power pure copper motor, uniform and stable operation and longer service life6. Blue LED display, HD display, anti dazzlePrecautions for safe operation1. Please connect the power supply according to the voltage indicated on the tool.2. When using tools at heights, be sure to hold the tools tightly at any time.3. Do not p the tool before it stops completely.Safety precautions of hot air gun1. Do not use the hot air gun as a hair dryer.2. Do not directly point the hot air blower at people or animals.3. Do not use near ins or es.4. Do not block or cover the hot inlet and outlet.5. Do not touch the nozzle when the hot air gun is used or just after use. The handle of the hot air gun must be protectedKeep dry.6. The hot air gun can be stored only after it is completely cooled.Maintenance and repairDo not use turpentine, mixture, oline or the same for cleaning.1. When stopping the operation, please slowly lower the temperature and blow out all the hot air in the air duct before turning it offTurn off the switch, and erect the hot air duct vertically on the flat worktable.2. When storing the hot air duct, please confirm that the hot air duct has been completely cooled.3. Regularly remove the dirt accumulated at the air inlet and keep the air inlet and outlet clean.4. Check all extended insulated wires. If damaged, please rep them immediately. Do not use damaged insulated wiresEdge wire, because it may be injured by if touched.5. All maintenance must go through an authorized service center or other qualified service organization to ensure securityIntegrity and reliability.