Fishing Crip Holder Catcher No Hurt Lure Plastic Fish

Welcome to my store, we have many kinds of price products, we launch new products every day, please follow my store and pay more attention, for more products, Please click on the seller information to enter our store to buy, we hope give you a pleasant shopping experience. Thank you and have a nice day! 1. About fishing rod strength. The main effect of the fishing rod is achieved by the bending arc curve of the fishing rod, so the fishing rod cannot bend a certain section, which is easy to break. Many fishermen worry about the tip section being too thin and not strong enough when purchasing fishing rods, so they conduct bending experiments on the tip section, which is unscientific. Some fishermen also worry that the strength is not enough. This is not to worry, because the fishing rod needs to be stressed as a whole during the fishing process, not just a certain section. Therefore, to judge the strength of the fishing rod, an overall experiment must be performed. The method can be: one person holds the rear end of the rod body, the other person holds the thinnest end of the rod body, and the person holding the rear end vigorously lifts the rod body upward, constantly or bending the arc. Natural is qualified. 2. Regarding anti-rust and anti-corrosion. Fishing rods will often get wet during use, especially the high salt content of sea water, and many stainless steel accessories will also rust due to material or use problems. After the fishing rod is used, open the thread of the tail piece, wash the sand, salt and other dirt in clean water back and forth, and then use a dry rag to clean the surface moisture, and finally place it in a cool and ventilated environment to dry. Store after drying. If there is dirt that is not clean, please use soapy water, do not use organic solvents such as gasoline, thinner, or a hard brush. Pay special attention to the fact that the fishing rod cannot be placed in a high temperature and airtight place such as the trunk of a car for a long time. All the above work is to prevent the metal fittings from rusting and the surface paint of the rod body from discoloring, blistering and peeling off.