For Corvette C8 Front ShoTower Covers With Mag Ride

For Corvette C8 Front ShoTower Covers With Mag Ride

For Corvette C8 Front Tower Covers

Whether you know it or not, there is an iue with the all new for Corvette C8 2020 that allows water to pool in the front towers. The towers are made from aluminum but the hardware isn’t and the pooling water causes the top nut and bolt to rust. Our for Corvette C8 Tower Covers provides a simple solution and prevents the water from entering the towers. Our covers are made from ble blaABS plastic and look like a factory piece once installed. Installation of our for Corvette C8 Tower Covers can be accomplished in le than 30 minutes with minimal tools.

Customers with front lift adjustable height option (Option code E60): for Chevrolet recently iued a technical service in regarding the reservoir cap leaking. The DOT 4 brake used in the front lift system can have a negative reaction with the s that are in the ABS plastic. It has been described to cause “catalytic embrittlement in the ABS, ing it very brittle and weak”. While ABS plastic is normally very ble this reaction with the brake can cause the cover to break.

Please ensure that your reservoir cap is not leaking prior to installation of the paenger side tower cover.

Tower Cover Product Installation Stlease note：Prepare Tools required before installationpry tool；10mm socketwire szip-tieHow to install (Installation Step)Please contact us if you need to install the video

1.Use the Pry tool or your hand to eject the side covers and the large center cover.e them heid on and pull upward to remove them.NOTE:(When you rep the shotower cover,please chewhether there is water collect in mounts,if yes,use a hair dryer or cleaning cloths to soak up the water.)2.Slide driver side under first:①Pull the wire harne out of the way from the driver's side tower using a pry tool,e sure that the wire harne is behind the shotower cover when install it.②Remove the bolt from the side of the coolant reservoir with 10mm socket③Take out tower cover and insert it into the tab between the tower and the reservoir.And tighten the bolt with 10mm socket.3.Then install paenger side:①Slide the paenger side cover into p by angling the cover towards the outer fender then rotating it into p.(Be careful not to bend or damage the hard line or coolant reservoir!)②Used a zip-tie and funneled it through the screw hole on the cover and tied it aside a tube which was mounted on the car.(Ensure the zip tie is around the rubber isolator.)4.Reinstall the center and side covers and the job is DONE.NOTE:The installation steps for Mag Ride and NON-Mag Ride are the SAME