For VW T-roc Automatic Stop Start Engine System Off Device Control r Plug Stop Cancel

TIPS:

Please turn off the power of the car before installation.After installation, the default setting is that you don't have to close the stop start engine function manually. If you want it for a moment, push the off on to restart the function.Note:1).The it may be different from our pictures according to different car styles, but the function is the same.2).Please e sure it is fit your car before you purchase,if you are not sure,please contact us and tell me your car model and year of manufacture, as well as provide me with photos of the automatic start-stop part of your car (it is better to pathe radio in the photo). Thanks.

The mode switching method：

The mode switching method adopts the 3+X method to switch.1. Turn off the start and stop first, wait for more than three seconds,2. Pre the start-stop switch three times in succeion (after preing it, the start-stop is turned on, wait for it to automatically turn off);3. Immediately after the start-stop is automatically closed, pre the start-stop switch three (or two or four times) consecutively, and then wait for the indicator to re. Then enter the automatic shutdown mode (or memory mode, factory mode).

start-stop module has an automatic shutdown function and a memory mode to avoid the deficiencies of the following start-stop functions:

1. The starting and stopping system of the vehicle is that the engine can automatically shut down when there is a ffic jam or waiting for a fic light, and then automatically start the engine when starting, which can reduce consumption and emiions.

In some case case , the automatic start & stop system can monitor the driving. If the safety belt is not fastened, the automatic start&stop system will not work normally. After the car stops, the safety belt will be released. Even if the brake is released or the oil door is sted on, the engine will not restart. But the automatic start & stop system, many car owners s that this design is not good, very upset about it. Some car owners have to pre the start stop switch on to turn off the start stop system every time they get on the in. If they fail to turn off the system once, they will not turn on the frequent operation again by default.

2. It is neceary to turn off the automatic start and stop in following situation :

1、 If the vehicle drives on the ramp , try not to turn on the automatic start and stop, because the automatic start and stop time is very short, the start and stop of the engine on the ramp may cause the insufficient brake force of the vehicle. .

2、 when the air conditioner is running at full power in the hot weather in Summer, it is better to turn off the automatic start stop function, because the air conditioner needs to consume a lot of power, and when the engine is stopped, the power of the car may not be enough to drive the air conditioner, which will e the paengers feel uncomfortable. .

3、 when the vehicle is driving in wading, it is better to turn off the start stop system, which is to prevent the engine from stalling when it needs to be stopped in driving, and the exhaust preure suddenly decreases at this time. It is very easy for water to flow bainto the engine from the exhaust , which causes the engine to fail to start.

4、 In case of serious ffic jam, it is also recommended to shut down the automatic start and stop, because at this time, the engine will stop working for a time, the temperature of the combustion chamber will be reduced, and incomplete combustion of carbon hydroxide and paraffin will form carbon deposition and attach to the inner wall of the cylinder. Carbon deposition will e consumption higher and power weaker. This is an automatic start stop function designed to reduce consumption, which in turn increases consumption.

3. even the battery in the car was emhanced one . but it also have a big challenge for the battery . so if it's too often stop & start . suest to switch off the start & stop system

4. if you want to disable the start & stop system permatenly , you need change the code by code system (if you don't have this tool , it's not easy ), but if disabled by setting . it will permatenly disabled .

NOTICE:

Please e sure your car inner part same as our link photo, then your car can use the start-stop module.[if you are not sure,please contact us and tell me your car model and year of manufacture, as well as provide me with photos of the automatic start-stop part of your car (it is better to pathe radio in the photo).]