HD M6S HUD Car Head Up Display 2 Overspeed Security Alarm Windshield Display Car Auto Electronics Accessories KM h

Features:

1. Decoration light2. Engine speed3. Fault code alarm icon /Water temperature alarm icon /voltage alarm icon/igue driving reminder icon4. Light r5. Unit for multi-function: ℃ -degrees Celsius, KM/H-kilometer per hour, V-voltage ,MPH-mile per hour,℉-Fahrenheit6.Multi-function switch zone: vehicle speed / voltage /water temperature /when car power off, this p can show single driving distance7. Set icons and icon

Troubleshooting:

1.The screen without any display, and no powerPlease do these operations:①If cable is tight enough,pull the cable down several times②Try another car to test③Please maintain the interface if it is damaged.2.When HUD power on, HUD only shows the voltage and be automatic power off ar 30 seconds driving.HUD just available for cars with 2 and EU- agreement(European:manufactured ar 2003, Other region: ar 2007)HUD Products don't support J and I, It is recommended to change the trolley test.3.Wrong operation lead to crIf your car equ with other devices or If your car had been modified will cause a crash,unplug other devices and do the factory settings (more details please refer to the menu table)4.Inaccurate SpeedPlease cheif the speed unit is correct,the default is KM(speed unit switching reference setting item)Ar the power is turned on normally, pre the dial on for 2 seconds to enter the system setting. Push right to adjust the speed adjustment and fine-tune it.(If the dasard displays 100 Km/h, HUD displaysKm/h, adjust the default from 107 to 102)5.HUD turn off when step on the brakes, wait for the ffic lights or automatical start and stop the car.For Start-stop car, when it been braked, the engine will stop running,then HUD will turn off. Please find menu 13, adjust the default to 180 ( means 180 seconds)6.HUD can not auto power off(RPM or Speed not at 0)When HUD is power on,pre in the on for 5 seconds to enter into menu,set to menu 12. Change the voltage from 0 to 13.2V or 13.5V. Once the adjustment finished,pre in the setting on for 5 seconds to save and exit.7.Ar HUD power off, restartFind menu 12, adjust the default voltage to 13.6-13.8 V

Auto-match models, plug and play

According to or EU,( the on-board auto-matic diagnosis system) plug and play.- Judgment method:Open and find the sticker under the hood.lf 2 CERTIFILE can be installed (as shown in Figure 1)Or chewhether there is an automobile diagnosis port under the steering wheel (as shown in figure 2)(u.s. cars can be used ar 2003 and most other cars ar 2007.)

Technical

1.Envment temperature:-40C- +80C Barometric pre: 86-106KPa2.Relative humidity:10%-95% Envment voice: