High-Power 30,000 Volt High-Voltage Package Drive Board Inverter Electrostatic Fast F Charging Bag

Product parameters.

The name of the product; a new generation of high-voltage bags.

Parameters:

The working voltage is 12V.

One of our high-voltage bags is equivalent to more than 6-8 black-and-white high-voltage packets.

High voltage output 3000V, with over-current protection.

Feed protection is lower than 8.5V to stop high voltage concuion.

Support is full of self-stop control signals.

With work indicator and safety mounting seat.

High output voltage.

Increase input line.

No welding.

ed ch

Fluke .

The measured no-load voltage is 32950V

3000V high voltage package.

The high-voltage package has a built-in protection circuit, which makes a good distinction between the high-voltage package and the low-voltage package to protect the hine from dam the circuit because of short circuit.

Upgrade new featur.

The input line is added in the new model, which is convenient for customers to aemble without welding.

Input line length 20cm, output line 35cm

Heat sink.

After the improvement of three generations of products, the has been thickened to make the working performance of the product more stable and the ed ST brand FET.

The third generation products are upgraded to high current 110A, high withstand voltage 80V, low internal resistance 0.0065 European advantage, low heating, high power, durability and other characteristics far exceed the performance of domestic or previously ed 75NF75.

The factory enters the DST brand.

Driver ch.

The ch is the most ant component in the core of the system, the ch determines the voltage output, power, efficiency conversion, rple size of this board, only a good ch will send back the best effect and stable quality.

Line safety device.

When the circuit is seriously overcurrent and short-circuited, you can protect the circuit and fuse the fuse, so as to prevent the of the fault from expanding even if your non-profeional maintenance personnel can replace and fix the fault on your own.ed non-inductive resistance.

The so-called non-inductive resistance represents the performance of negligible inductance and non-general s, so the s are used to protect the current limit and provide the ch with over-current protection signals. only by using ed non-inductive s can the ch work in a stable and optimal state.

Quick connection terminal.

The use of pure copper flame retant I industry terminal, the advantage of pure copper conduction current, fast and convenient installation of wire can be a screwdriver.

There is no need for welding in disaembly and aembly.

Anti-re protection diode.

Two high-power diodes are connected in parallel to reduce the voltage drop lo of the diode and increase the current conduction capacity to completely avoid the unneceary lo caused by the negligence of the positive and negative electrodes.

Operation indicator.

This indicator can visually reflect the working status of the product, for example, when multle boards are working at the same time, you can distinguish whether it is working properly by observing the indicator light.

Can be independent: all boards can be broken into independent driving plates adjacent positions are mechanically V-cut. Independent driver board benefits. High power and high efficiency, even if there is a problem with a drive board, it will not affect other work.

About shping
Shping and Pack All it will be double checked and well packed before sending.It will be dispatched within 2 business days after buyers pay for the order. It usually takes about 14 to 18 working days for delivering the package to the destination(for e areas,it may take a little longer). 

Special Announcement:
Please fill in the correct and detailed consignee, address and phone number in the order. For fast and correct delivery.If you do not receive order within 30 working days,please feel free to contact Customer Service before leaving Negative and Neutral Feedback, we will do our best to help you resoe the problem.TaxNo, you will only pay what is quoted as total cost at checkout, no more. You are not expected to pay any additional duties or taxes. If you are asked by Customs or our logistic partner to pay duties, please contact our Customer Service .

Your 100% satisfaction is very ant to us
If the product is not on good condition, You can return this product within 14 working days, please contact customer service center before returning.FeedbackYour satisfaction is our first priorityIf you receive the order and it is in good condition,we would be grateful if you would leave us 5 star Positive Feedback for the transaction.