IGVoltage Capability nsistor MOS Triode LED Voltage Capability Test Tool 120~2700V Reusable Blue Standard

IGVoltage Capability nsistor MOS Triode LED Voltage Capability Test Tool 120-2700V Reusable (Blue Standard)

Product sellins and features: 1. The output voltage is 110-2600V DC. You can turn the voltage adjustment on clockwise to increase the voltage and counterclockwise to decrease the voltage.The output current is 0.25~3.4mAh. You can turn the voltage adjustment on clockwise to increase the current and counterclockwise to decrease the current.2. Widely d: This tool can be widely d for MOS, nsistor, IG, , , bridge maximum voltage capacity testing, voltage verification of s and varistors, LED backlight and lamp board testing, etc3. When testing MOS nsistors, nsistors, and s, it is recommended to adjust the current to the minimum scale of 0.25mA. When testing the LED backlight board, it is recommended to adjust the current to the maximum scale of 3.4mAh.4. Portable size: The small size of this tool is very convenient for daily . You can carry it in a tool bag without occupying too much storage space.5. Equped with a built-in 660mAh high capacity battery for power supply, it can be charged in a timely manner through the Type-C interface.Product s:Battery capacity: 3.7V 600mAHCharging port: TYPE-CInput: 5V 1ACharging current: Max.550mAOutput voltage: 120-2700VOutput current: 0.2-3.8mAApplicable components: MOS tube/IG/triode/Electrolytic /LED/MOV/unidirectional thyristor/rectifier bridgeTest objective: Breakdown voltage value of electronic componentsPower supply: built-in battery 500mahAttention:1. Do not it to test 450V/220UF and other high-voltage large Electrolytic . It is poible to test low-voltage s such as 2200UF/35V.2. If there is no output voltage when preing the red high-voltage start on, it is likely that the battery voltage is lower than 3.1V and the cannot be powered on. It needs to be charged in a timely manner.3. Only when testing LEDs and voltage regulator s can the output ot be powered on. It needs to be charged in a timely manner.3. Only when testing LEDs and voltage regulator s can the output current be adjusted to the maximum value. For testing other components, the output current can be adjusted to the minimum value to avoid dam the componentsStandard: BlueMaterial: plasticcolour: As ShownPackage Contents:1 x nsistor Only the above package content, other products are not included.Note: Light reflection and different displays may ca the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.