Kebidu 433 Mhz Auto Copy RF Remote Control 4 Channel Cloning Gate for Garage Door Remote

Check your device Frequency and IC model before buying
Must be meet the following three conditions:
1. You must have a good remote controller. (Or will copy the bad command, can't work)
2. You need to know the device frequency and IC model of your current remote controller.
3. This remote controller is mainly suitable for rolling doors, retractable doors, Road gates, etc.

For example: open your remote controller and check device frequency 433, the IC model is 2264, and you also have a usable remote controller, will be ok to choose this product.

Chips could be copied
2260(all manufacturers);2262(All manufacturers);PT2264, 5326(All manufacturers);SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014, SMC918series,527(All manufacturers);1527(All manufacturers);2240(All manufacturers);HCS101, HCS200/HCS201(part code),HCS300/HCS301, part single microcomputer....

RF frequency type: 433 (Listing product only supports 433.92 MHZ)
Duplicate Your Existing Remote Controllers so you always have a backup:
1. Vehicle central locking systems
2. Garage doors
3. Electronic gates
4. Electrical appliances/Home automation i.e. lights
5. Car sunroofs
6. Car/Motorbike alarms

Specification:
Operating Current: ≤12mA
Operating frequency: 433.92Mhz
Transmitting power: ≥10mW
Transmission Distance: meters (open)
Frequency deviation: ± 0.2MHz
Transfer rate: 50--60KHZ
Working temperature: -20~70℃
Storage temperature: -10~ 50℃
Humidity: 85% or less

Package includes:
1x Remote Control
1x Instruction manual

Code cleaning method:
Press the unlock button and lock button at the same time(some shells are the up button and down button), after the LED indicator flashes three times, loosen any one of the buttons while the other is kept pressing, then push the released button three times, the LED indicator will enter into the fast flashing status. At this time all the memory data is cleared, and the cleaned remote control will not have a lighting LED indicator no matter which button you press.

Copy method:
One hand keeps the remote controller, while another keeps the copy remote control, the two remote controls should be placed as closely as possible (the ideal situation is to put the two remote controls on the desktop side by side with zero distance), respectively press down the copy button, when the LED indicator flashes quickly after three flashes, this copy is successful, other key operating methods are the same. Some remote control has a smaller transmitting power, so the remote control should be placed back into the copy remote control to be operated. For the presence of noise, it should avoid interference to operate, If the copy is not successful, it should recopy after clearing the code.