Ppf S-healing TPU Car Headlight Anti Scratches Tinting Film Wrap Protective Car Film

Features:

S-healing,Stretchable, Scratch Resistan Item.

Hot repair Easy Removal with No Residual.

Suitable for Any Headlights, Fog Lights, Side Marker lights or Body surface etc(DIY)

Name:Car headlight film

Material :TPU

Size:Width 30cm/Length 1/1.5/2/3M

(The appropriate size for general car headlights is 1.5 meters. If your car headlight size long, please choose 2 meters.)

Color: Clear/light black/light gray/blackened/drak black

(Due to the difference between different monitors, the pictures may not reflect the actual color of the item)

Easy to remove:our film is easy to be cleared and will not leave the in your car. Film can be heated properly by hair dryer, baadhesive will be soft to removed

How to Install:Clean the dust of the headlights and spray water, then tear off the two layers of the sticker, spray water (purified water or with water and neul ) on the adhesive, to facilitate adjustment when pasting, and heat with a hot air gun during the installation proce so that the film can be Stretch and stito the lights, and use a scraper to remove water and air bubbles to e the film more fitasy to be cleared and will not leave the in your car. Film can be heated properly by hair dryer, baadhesive will be soft to removed.

ant Reminder:

About TPU Soft Film:

1. The TPU soft film is washable and can be installed multe times.

2. Spray water or detergent water on the film and screen to help out bubbles.

3. The soft film can be installed many times without damage. If installed failed, just removed it and installed it again until succeful.

4.TPU is one kind of rubber and it is elastic, if it is folded, the crease will disappear when it stion the car. Unle there is a hole, the folded will not affect the installation.The screen must be cleaned before installation and ensure that there is no dust.

If you are not good at DIY, it is best to ask local profeional installers for help. But if you don't find it troublesome, you can install it yours, but there may be a lot of bubbles after installation, you need to try repeatedly until the bubbles are removed and the installation is succeful. We will not accept the for manmade mistakes or due to wrong installation.

Installation Tip :

Step 1: Prepare a spray bottle (water and 1 drop of shower ), a rag and a scraper, and thoroughly clean the application area.

Step 2: Remove the film and spray a certain amount of water on the sticky side.

Step 3: First align the holes, which will help align the entire film.

Step 4: Use a scraper to scrape off water and bubbles from the center to the corner. Cut off exce film.

Step 5: Use a hot air gun, hair dryer, or to flatten and secure uneven areas.