Signal Invertor Convertor Acts as Interface Between Level Tank Sender for All Level and r

s are designed to work with a specific range. Different automobile and manufacturers use different ranges to correctly operate their s. This can cause probl for a person who is updating their vehicle with new s or a new tank and sender.

Descrtion:

FM101will convert the input resistance signal to a target resistance signal, so that /Water can work with different type/rangeof /water .

• Acts as Interface Between Senders & s

• Reads any sender

• Works with any

• Accurately Corrects Mismatch & Erratic Movement from Slosh

• Piup Voltage Input signal or Input Signal

• Custom Calibration for empty, half level and full

• Mini Size 20(w) x 16(H) x35(L) mm

Store mode:

The Full, Half, and Empty position can be programmed.

The"in-between" positions between F, 1/2, and E are calated by the microproceor and are linear.

The"power on" start position is selected from either the sender position or the programed position.

The output is a npn width modulated signal which may cause"buzzing"in undamped s.

1. Power off. Wait 5 seconds. Pre "F" switch and power on then release "F" switch.

2. Red LED only will turn on

3. Set to Full position. Adjust to Full using the calibration screw on FM101.

Pre "F" switch then release.

4. Set to 1/2 way. Adjust to 1/2 way using the calibration screw.

Pre "H" switch then release.

5. Set to Empty. Adjust the to Empty using the calibration screw.

Pre "E" switch then release.

6. Adjust the calibration screw to where you want the to go to when the car is started.

(Usually this will be the position of the pointer when the car is off)

Pre "E" and "F" simultaneously then release.

Power on mode:

1. Power off. Wait 5 seconds.

2. Choose where you want the to start from when the car is started(Usually the "off position" )

If you want the to start at sender position. (suits bi-metal and cro s with damping)

Pre "E" switch and power on,release "E" switch.

If you want the to start at the preset position(set in store mode step /6). (suits s with no damping)

Pre "H" switch and power on, Release "H" switch.

3. Green LED will turn on.

Run mode:

1. Power off, Wait 5 seconds, then power on.

2. Green LED will turn on.