Suitable for TYD9 TYD10 TY588 TY618 TY06 model TPMS external r and built~in r

Please note! the rs sold here are only suitable for the of Develuck/Jansite/Srnubi/Vtopek brand products, not suitable for other brand products. Ar purchasing, please be sure to note what type of needs to be adapted to , or contact customer service for consultation. Avoid incompatibility and not working properly ar purchase.TYD9/TYD10model external r pairing steps: first remove all 4 external rs, and then pair them in the order shown below.1; Pre and hold the right on as shown in Figure 1, wait for Figure 2 to appear on the screen, and then enter the pairing mode.2; Then install the r A to the left front wheel, wait for the tire preure data to be displayed on the screen, it proves that it has been paired and connected (Figure 4)3; Clithe right on, and then enter the tire matching mode4; Then install the r B to the right front wheel and wait for the tire preure data to be displayed on the screen to prove that it has been paired and connected (Figure 8).5; Clithe right on, and then enter the tire matching mode6;Then install r C on the left rear wheel and wait for the tire preure data to be displayed on the screen to prove that it is paired and connected (Figure 12).7; Clithe right on, and then enter the tire matching mode6; Then install the r D on the right rear wheel and wait for the tire preure data to be displayed on the screen to prove that it has been paired and connected (Figure 12). At this point, all pairing and connection are succeful, OK.

二;Internal r pairing method:Please note; (internal rs) need to release the air preure of all four tires

1;The first step is to inflate all 4 tires of the car until the tires are flat.The tire should be deflated to a dry state: correct

Tire full state: error (tured above)

2; also enter the setting mode and perform pairing connection with the corresponding r

3;Then inflate the tire, the fing bar on the screen will change to tire preure data, which means that the r has been succefully connected to the display.

Then proceed in order, filling one tire, and then pairing one until all tires are paired.

TY588/TY618 model external r pairing steps: first remove all the 4 external rs, and then pair them in the order shown below.Dear friends, if you have purchased a kit with 8 rs for the TY588 model, it is d for the Spring Festival and winter tires. When we need to rep a new set of tires, then we need to match all the rs one by one, becaThe can only display and remember a set of tire r data and matching it.Right on: Power on: d to turn the power on and off

Left on : Pairing on : d to pair the r and display

Pre 8 times to turn on pairing modeAr the first tire is paired, pre the left pairing on to switch to the second tire for pairing

Ar the second tire is paired, pre the left pairing on to switch to the third tire for pairing

Ar the third tire is paired, pre the left pairing on to switch to the fourth tire for pairing

When all 4 tires are matched, pre the confirmation on in the middle to confirm.

The above is the proce of pairing the first set of rs.TY588/TY618 model built-in r pairing steps: first release all the air preures of the 4 tires, and then pair them according to the order shown in the figure below.

The first step is to inflate all 4 tires of the car until the tires are flat.

The tire should be deflated to a dry state: correct

Tire full state: error

Step 2: Start pairing the first tire (front left wheel). Inflate the first tire and pair the display with the r at the same time.

Start to up the tires and pair them at the same time