Temperature Controller Dial module LED Display Heating Cooling Regulator Thermostat Switch WT01

XY-WT01Dial Thermostat Heating RefrigerationProductFunction:

Set Temperature ---- SetT;

Back Temperature-----BackT;

1.HeatingMode’H’：

When Temperature≤SetT–BackT;Relay conduction, heating equipment begin to work;

WhenTemperature≥SetT,Relaydisconnect, heating equipment stop work;

2.Refrigeration mode’C’：

When Temperature≥SetT+BackT;Relay conduction, refrigerationequipment begin to work;

When Temperature≤SetT;Relay conduction, refrigerationequipment stopwork;

3.High Temperature Alarm’ALA’：

When Temperature≥AlarmTemperature,The system opens the sound and light alarm, and disconnects the relay, any key stops the sound light;

4.Delay Start‘OPH’：

When a normal heating or refrigeration work is done, the system starts to timeT, and only after theT≥OPH, the system can carry out the next round of heating or refrigeration work;

5.Temperature Correction FunctionOFE(-10.0 ~ 10.0℃)：

The system will work for a long time and may have deviations that can be corrected by this function,Temperature=Measured+Calibration；

6. Remote Read/Set：

The s such as setting temperature, back temperature and temperature correction can be set through UART.

7.Real-time Temperature Report:

If the temperature reporting function is turned on, the product is nsmitted to the terminal by the UART at 1s intervals, which facilitates data collection;

8.Relay enable (default enable):

If the relay is disable, the relay remains disconnected;

9.Restore factory Settings:

At the same time pre the STOP, set key more than 3S, restore factory settings;

Working modesetting /back temperature :

1.In the running interface, short preSETkey, enter the Quick setting interface;

2.After entering the Quick Setup interface, switch the s

3.Through theUP DOWNkey, modify the value, support short pre/long pre;

4.Long preSETto build more than 3S or continuous 6S without any key operation, exit quickly set the interface, and save s;

Alarm temperature/delay Start /temperature correction:

1.In the operating interface, long preSETmore than 3s, enter the s to set the interface;

2.Enter the to set the interface, through the short preSETkey to switch to set the s;

3.through theUP DOWNkey, modify the value, support short pre/long pre;

4.Long preSET3s above or continuous 6S without any key operation, exit set interface, and save s;

How to turn on high temperature alarm (default off):

Enter the setting interface, switch to the alarm ALA, turn on or off the high temperature alarm function by short preing theSTOPon, and if the high temperature alarm function closes,ALAdisplays '----' as a reminder;

How to turn on delay start (default 0ff):

Enter setting interface, switch to alarm OPH, turn on or off high temperature alarm function by short PreSTOPon, if high temperature alarm function closes,OPHshow '----' to remind;

Serial Control(MCU UART)

Communication standards:9600bps Data bits:8Stop Bits:1CRC:noneFlow control:none

CMD

Description

start

Start temperature report

stop

Stop temperature report

read

Read s setting

on

Relay Enable

off

Relay Disable

S:XXX

Setting Temperature

-50 ~ -01

00.0~99.9

100~110

B:XX.X

Set Back Temperature(00.0~30.0)

OFE:XX.X

TemperatureCalibration(-10.0 ~ 10.0)

ALA:XX.X

Alarm Temperature(-50.0 ~ 110.0)

OPH:XXXX

Delay Start(0 ~ 9999Minutes)