Universal 12V Auto Engine Ignition Start Stop on System Sta Car Alarm e Starter SUV PEK Entry System +Gift

Please kindly Note:If the car was equipped with a steering wheel loand  chip anti-theft , before to modify one-on start ,the car must be released from the car steering wheel loand chip anti-theft and then can be used normallySpecifications

Fit For:12V battery car, van, pickup truck, SUV, etc., general purpose products

Operating Voltage:12V±3V

Quiescent Current:le than 10mA

Working Frequency:433MHz

Features

-Q6C ligent one key to start the system, using smart chips, can provide a key to start / flameout, convenient and simple.

-PKE keyle entry, automatic r switch lofunction, near the car 2 meters, the automatic r unlock.

-There is a e start / flameout, countdown ten minutes off function.

-Summer cool car, winter warm car, no longer bear the car when the uncomfortable.

-With the identity function, the e control is not able to start normally.

Key Operation

-Do not pre the brake, short pre to open the ACC sound, then pre the ''on'' dasard, the indicator light fes, then short pre off, you can cycle operation.

-Brakes, short pre, the system ignition start, light light.

-When the flame is turned on, the brakes are short preed and the system is turned off.

-Step on or not brakes, pre, the system can let go after the ignition, light light

Package Included:

1 x Host

2 x e Control Handle

1 x Start on

2 x Sensing

1 x Start Harne

1 x Harne

1 x Restore on

1 x Manual

Q&A :1.How to find the ACC wire?Please rearrange the 6P cable, after you twist the key to the first gear position (you can listen to music at this time), measure the line that has electricity on your  car is the ACC line.2. For your 6p cable, but my  car is only 5p. what can i do ?If your  car is a 5P line, the right connection is normally 1 power line, 1 ACC line, 2 ON lines, and 1 start line. If you didn't follow this step, it means you got wrong installation. pls recheck it again. and pls remember 2 ON lines need to distinguish which is ON1 line and which is ON2 line. If the two ON lines are always charged at the time of startup, you need to connect the two ON lines in parallel.3. How to tell the wire ON1 and ON2?If you test these two ON lines at startup, one of the two that always has power is the ON1 line. And If the other one has instant power is the ON2 wire.