V53 universal lcd led tv controller driver board VGA HD~MI USB TV og full kit 30pin 2ch 8bitds 4 lamp ccfl

This kit support the panel in following condition:

Interface Type:DS (2 ch, 8-bit) , 30 pins , ConnectorLight Source:4 pcs CCFL , 50K hours , Without Driver

For example:

LTM190M2-L31 HT190WG1-100 LM220WE1-TLA1 LM220WE1-TLB3 LM220WE1-TLD4 LM220WE1-TLE1 M190A1-L0A

M240HW01 V0 M170EG02 V3 LTM190EX-L01 G170EG01 V0 HT170EX1-100 HSD190ME12-A00 LM190WX1-TLA1 M236MWF1 R0 CLAA170EA07Q LTM230HT01 HT170E01-101 M201EW02 M220Z1-L03 QD17EL07 Rev.11 M240HW01 V2 HT17E11-300 MT220WW01 V.1 ect.

Download:

https://drive.google.com/file/d/1Dr46NBxl4sRfxnhPFBUJy7LJquBEsF

Program update method:

1. Prepare a USB f drive and download the program we provide

select the required from the file(select according your screen resolution)andcopy Z53BK1.binto the USB f drive.

2.set the voltage on board(it is according your screen input voltage :3.3v/5v/12v)

3.plug U disc to the board, and plug 7 key board,then plug power adapter,power on. then you can see the light on key board will be fing. it is mean the board is installing program. (at this moment , don't let power off!)

4. ar few minutes, the led will be stop fing, mean finished. then power off, Pull out the USB , then plugds cable and . power on . On screen "no signal" , done.

Note:

voltage should be set correctly(3.3v/5v/12v);

The power requirement of 12A;

don't let power off when installing program;

The screen line not to re and dislocation;

selectds cable and should according your panel specs.if you can't select, pls offer panel number to us, we will help you.

Configuration & General Precautions1.Protect the board from static electricity to avoid damage to the IC.2.Keep the board away from conductor when it is working.3.Don’t pre, distort or disaemble the board.4.Clean the board with soft dry cloth when it’s dirty.5.Don’t switch on the power supply before panel is correctly connected.6.The brightne of panel is influenced greatly by temperature, you should measure it ar power on 10~30 minutes.7.Keep the board surface clean. Check the appearance of the board if there has any defective parts, such as damaged,weighty nick, etc.