ZIQIAO Car Rear View Parking Camera Universal HD Night Vision Waterproof Auxiliary Camera HS001

Universal Car Rear View Camera HD Night Vision Waterproof Auxiliary Parking Camera Car Acceories

HS001Specification

Signal mode: CVBSImage r: CMOSVideo format: NTSCPixel: 728 x 512Resolution: 500 TVLine angle: Diagonal 170 degrees, flat angle 140 degreesRated voltage: DC 12VWaterproof level: 68Length of power cable: 1mLength of video cable: 6mWorking temperature(Deg.C): -30 - +80

HS001Packing List

1 x Car rear view camera1 x 6m video cable1 x 1m power cable1 x User manual1 x Hole

HS001BSpecification

Signal mode: CVBSImage r: Meo format: NTSCPixel: 1280 x 720 angle: 160-170 degreesRated voltage: DC 12VWaterproof level: 68Length of video power cable: 6mWorking temperature(Deg.C): -30 - +80

HS001BPacking List

1 x Car rear view camera1 x 6m video power cable1 x User manual1 x Hole

Parking guide line optional

The HS001 HS001B camera defaults to a rear view camera without parking guide line.. If you need a rear view camera without a parking guide line, do not cut the wire.. If you need a rear view camera with a parking guide line, cut the wire.

Avoid Danger

Rear view camera is clearly visible day and night, allowing you to park safely.

Wide Angle: Diagonal 170 degrees, flat angle 140 degree

High resolution and wide viewing angle can chethe blind spots during the proce to ensure your safe driving and avoid accidents.

68 Waterproof Level

68 high-grade waterproof design for using in extreme conditions.

Product Size

Due to manual measurement, there may be an error of 1-2mm.

If you need a filter rectifierto e the video signal output normal. Please clion the ture below to learn about ordering!

In some models of German and American cars, ar engine starting, the output voltage is disturbed.Instead of pure direct current, it powered by ims rimposed on top oscillo. If can use an oscillo to test, you will find that the power supply line of the camera is directly on the light, because of working voltage unstable cause the camera doesn't work, the output of the video signal is not normal, so you will see on the screen display has serious interference, shaking or can not switch back.

Installation Method

The installation instructions are for reference only. It is recommended that a profeional installer install the camera.1. Install the camera in the area near the plate light.2. Adjust the of the camera to your best position.3. Connect the video output(yellow wire) to the monitor.4. Connect the power cable(red and black) to the power supply of the car's light, while , the monitoring system automatically start working, you can see the condition of the car tail clearly.