Multi-head Belt Rotary Punch Original Wooden Handle

Multi-head Belt Rotary Punch

1. Material: wooden handle + brass connector + steel punch
2. Product standard: 1 punch handle + 6 punches
3. Product use: widely used in paper/leather/belt/cardboard punching operations
4. One-handed operation, comfortable grip
5. 90 degrees perpendicular to the leather surface, press the handle at the required position to punch a hole
6. When punching, please pay attention to the rubber pad (punch plate) below to protect the cutting edge from damage
7. 5mm wide and thick chip removal, easy to discharge a large amount of debris, making punching smoother
8. 6 different specifications of aperture, loosen the nut, replace the punch, and adjust the hole size according to your own needs
9. Aperture display: 1.5mm; 2.0mm; 2.5mm; 3.0mm; 3.5mm; 4.0mm
10. Length: 140mm
11. Handle width: 28mm for logs; 24mm for black wood
12. Note: The commonly used punching models are 1.5/2/2.5/3mm
Instructions:
1. Remove the screw on the top of the connecting rod, install the required punch, then tighten the screw to fix the punch
2. Fix the leather, hold the punch 90 degrees perpendicular to the leather surface, and press the handle at the required position to punch a hole (if the leather is thick, you need to press it several times)