New 220v IR Infrared Module Body Intelligent Sensor Light Motion Sensing Switch

: White

Quantity: 1 pc

Voltage: AC 180V-240V

Output: Relay

Load : 200W

Induction distance: 3m - 8m

Induction angle: 120°

Light intensity of illumination: 6

Time extension: 30s±10s

Switch Dimension：7.45 x 3.85 x 2.8cm / 2.93 x 1.51 x 1.1"







Wire:

White - Sensor

Black - Ground

Red -





Feature:

(1)Infrared technology based automatic motion sensor switch.

(2)Automatic turn ON/OFF while detected people come or left.

(3)Automatic locked in day time to save energy.

(4)Sensitive control,not the day or light sensors,at night or in low light senses.

(5)Automatic Delay - After the switch is turned on, if a person within the scope of activities of the sensing switch has been turned on;if people leave the sensor range stated last time before leaving as a reference point,the start delay.

(6) By adjusting the delay time of the switch resistance set the time. Usually about 20 seconds - 40 seconds

(7)Easy to install or replace existing switch.



Instructions for use:

1.Please on the housing according to the wiring diagram switch installed, one minute after initialization time, in the initialization time for the uncertain state of the switch-off will flash three times in a row, after a minute into the normal working state, such as during the day to check whether the switch normally covered by hand or with a black object file live switch, so that the light dimmed, lights can be turned on.

2.Delay and sensitivity is factory set delay time and luminosity prevail, the switch can not adjust the delay time and the luminosity

3.When installing the switch, do not switch installed in the direct glare and location of the and export of hot and cold air, not loaded too much noise in the environment. Otherwise they will be false signal lights, can not achieve energy savings.

4.This switch allows parallel access, but must pay attention to the problem, the product can not be greater than the specified load. The load switch on the standard are normal, lower than the standard load to extend the life of the switch.











Considerations:

- Disconnect the supply during installation to ensure safety

- Prohibit the use of more than range

- Can not be installed to water pour location

- range with changes in ambient temperature changes.Summer distance is relatively short,Winter distance farther.

- Can not be installed at the location below -20 degrees and above 60 degrees

- Do not place in direct sunlight

- Not recommended to be installed in a position of moving objects
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a